Search results for "Contact pressure"
showing 6 items of 6 documents
A preliminary investigation of the effect of contact pressure on the accuracy of heart rate monitoring by wearable PPG wrist band
2019
The increase of safety and health monitor of workers has become a crucial objective to prevent excessive physical workloads, injuries, accidents and errors. Heart rate (HR) is a very important physiological indicator which could properly describe the workers’ physical status. Recently, wearable photoplethysmographic (PPG) wristband trackers have been utilized to measure HR without hindering normal gesture of workers. However, the quality of PPG signals is highly affected by human physical motions, resulting in a poor reliable HR estimation. Specifically, during different activities and gestures, PPG sensor contact pressures may have an impact on the quality of the heart rate signal. To appr…
A new quasi-static multi-degree of freedom tapered roller bearing model to accurately consider non-Hertzian contact pressures in time-domain simulati…
2014
The accuracy of the fatigue life calculations in rolling bearing simulations is highly dependent on the precision of the roller-raceway contact simulations and the ability to accurately include structural deflections of the supporting structure. Several different methods exist to simulate the pressure distributions, and in time-domain bearing simulations, where many contacts need evaluation, the simple and time efficient methods are more popular. These methods underestimate the fatigue life reduction due to roller end effects, overload and misalignments. Furthermore, existing time-domain rolling bearing models assume that the bearing rings remain circular, which can be a poor approximation…
Experimental analysis of the contact pressure distribution in an off-road tyre
2009
In this paper the results of experimental tests are shown, lead by extended method of measurement, on a tire for an off-road vehicle 175/82 R16, inserting Prescale paper at the contact with the ground. The experimental analysis of the pressures is lead, in cross-sectional direction, in 5 zones correspondents to the middle of the single dowels constituting the tread. The results are analyzed by means of software predisposed to the scope so as to go back easily to the value of the pressure. The obtained results are critically analyzed and the result are compared with those obtained by the formulas of Rowland and MacLaurin, and by the nominal pressure at ground, concluding that the expression …
A study on the effect of contact pressure during physical activity on photoplethysmographic heart rate measurements
2020
Heart rate (HR) as an important physiological indicator could properly describe global subject&rsquo
Hot Impression Die Forging Process: An Approach to Flash Design for Tool Life Improvement
2005
In impression die forging the role of the flash geometry is fundamental since a proper design of the flash land strongly influences both the complete die filling and the die wear (i.e. the die life and the related costs). In this paper an integrated approach between numerical simulations and statistical tools was developed with the aim to optimize flash thickness in order to reduce die wear and to minimize material wasting. As wear is regarded, an analytical model depending on sliding velocity, temperature, die hardness and contact pressure was utilized during the numerical simulations of the process in order to reach a wear evaluation for different values of the flash design variables. Thu…
3D Data Acquisition and Numerical Analysis of a Footwear in Walking
2004
The aim of the paper is to set a procedure to study the load history of a footwear during a step with non-linear FE analysis. The geometric model tested was reconstructed from a real shoe by means of Reverse Engineering process, starting from dense point clouds acquired by non-contact scanning system. For each phase of the walk, the pressure values are obtained by a pressure distribution platform when tester is walking along the platform. The Finite Element model is easily generated by Hypermesh software using the CAD model. Ansys software is used to perform non-linear analyses. The procedure can be employed for improving the product performance in terms of durability, flexibility and comfo…